MinarcMig Adaptive 180 Manuel de service télécharger pdf (Page 12)

2.5.2 Threading the ller wire

1. Open the reel housing by pressing on the opening button and install

the wire reel in such a way that it rotates counter clockwise. You can

use either a 5 kg (diameter 200 mm) or 1 kg (100 mm) wire reel in the

machine.

2. Attach the reel with a reel lock.

3. Unfasten the wire end from the reel, but hold on to it all the time.

4. Straighten the wire end for approximately 20 cm and cut the wire in the

straightened location.

5. Open the pressure control lever which then opens the feed gear.

6. Thread the wire through the wire’s rear guide to the gun’s wire guide.

7. Close the feed gear and fasten it with the pressure control lever. Make

sure that the wire runs in the feed roll groove.

8. Adjust the compression pressure with the pressure control lever no

higher than to the middle of the scale. If the pressure is too high, it

removes metal fragments from the wire surface and may damage the

wire. On the other hand, if the pressure is too low, the feed gear slips and

the wire does not run smoothly.

9. Press the welding gun trigger and wait for the wire to come out.

10. Close the reel housing cover.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 25 26

Pas de commentaire

MinarcMig Adaptive 180 Manuel de service Page 12